Tool Type:
?
Can't go wrong with the classic
?
Creates cuts with triangular section, this makes for a nicer result with no visible gaps
Cut Parameters:
?
Thickness of your blade
?
Should be 85-90% of the material's thickness
Input Type:
Units:
?
Note that all this does is enable fractions (eg. 2 1/8) to be processed. Behind the scenes everything is processed in "units", thus using inches is 25.4 times less precise than mm.
Output Settings:
?
The length of the lines drawn in the output DXF
?
Shifts the output, for example if you want to cut on the right of the marks you would shift the output by minus half a blade width (like -1.35)
Algorithm type:
?
This software offers two different algorithms. "Primary" works best for most cases. "Simple-symmetric" is only useful if you want the cuts to be symmetrical, it works only on simple curves (parabolas and similar).
Control Points
Click to add control points. Drag existing points to reposition. Right click to save image.
Pondering...